cs2g-proton-vietnam-thiet-bi-do-duong-kinh-cap-proton-ptc-vietnam-1.png

CS2G _Proton Vietnam, Thiết bị đo đường kính cáp, Proton PTC Vietnam

Xuất sứ: UK

Hãng sản xuất: Proton

Liên hệ tư vấn

Ms. Trinh

trinh@pitesco.com

0914.738.179

trinh trinh

EXTRUSION CONTROL
 
NEXiS® CS2G Series Extrusion Controller
Economical insulation diameter control for standard extrusion applications.  
  • For control of one extruder from one diameter gauge.
  • Integrates with Proton Products DG Series Diameter Gauges for insulation diameter measurement.
  • 2-row, 5-digit, 7-segment LED display.
  • Single axis (NEXiS® CS2G) model controls the extruder based one axis of diameter measurements.
  • Double axis (NEXiS® CS2G-XY) model controls the extruder based on two axes of diameter measurements.
  • Panel mounted; optional stand-alone enclosure is available. 
NEXiS® CS2G - front view
CATALOGUE

Introduction 

The Proton Products NEXiS® CS2G Series of controllers are for use on wire insulation or other extrusion production lines.
NEXiS® CS2G Series controllers connect to Proton Products diameter gauges and speed and length gauges for measurement of insulation diameter and line speed respectively. These measurements are then fed into a PI feedback controller whose fully-isolated and floating output may be used to drive insulation extruders or capstan drives.
Insulation diameter is thus actively controlled and kept in tolerance by the NEXiS® CS2G controller.
image5a

Operating Modes

COLD DIAMETER MEASUREMENT

CS2G-image-01
The NEXiS® CS2G is connected to the Cold DG diameter gauge after the water cooling trough. The Cold diameter measurement is used to control the extruder so that the final insulation diameter is held within tolerance. Since the Cold diameter measurement is located far from the extruder, this control system response time is relatively slow (and dependent on the line speed), but no shrinkage offset is required.

HOT DIAMETER MEASUREMENT

CS2G-image-02
The NEXiS® CS2G is connected to the Hot DG diameter gauge before the water cooling trough. A shrinkage offset due to cooling is set by the operator and used in conjunction with the Hot diameter measurement to control the extruder so that the final insulation diameter is held within tolerance. Since the Hot diameter measurement is located close to the extruder, this control system response time is relatively fast.